3D printing Zero position problem

uArm Serial No.: (the No. at the bottom of each uArm reading “UARM-D43639DF659E”) SwiftPro

Firmware Version: 3.1.16

Operation System: Mac 10.12.6

uArm Controlling Method: uArm Studio with Cura 2.4.0

When i start uArm (with Cura 3D), it slams under zero before it can change.
He knocks on the floor.

Official Store
uArm User Facebook Group

English Channel

Hi @Nicola_Sassaro

Did you adjust zero point successfully?

Could you send me the video of uArm’s behaviour?

maybe the same issue as this?

there was a new version of Curaforuarm released, I don’t know where in cura you can check the version but make sure you use the most recent one.

Hi Cleo, my video link https://goo.gl/photos/MA28fU9vEEvZCDcUA
Print error (view picture) https://goo.gl/photos/TpTTJ7HBteN4bJDAA
Thanks, Nicola

Hi Feko, i don’t know, download new version CuraforuArm for Mac in website, but the version in preferences is 1.0
View the image

Thanks, Nicola

Hi Nicola, After check the video, it seems that even the zero point is above 10mm (we can’t see the zero point clearly), the arm still knock the table. If so please try the calibration steps in this link: https://drive.google.com/open?id=0B-L-tCvknXU9ZXBweVlYRXd5VHM
It might help you. Looking forward to your reply:)