i am getting some very strange behaviour from the wrist servo. it only works are specific heights. if the uarm is too high up, the wrist does not work. if Z coordinate is below approx 40 the wrist servo works again.
see this movie: https://www.dropbox.com/s/y1jnq6x0w6pv2hq/FJVID_20191126_125624.mp4?dl=0
what can i do?
uArm Serial No.: (the No. at the bottom of each uArm reading “UARM-UARM05051706CA”)
Firmware Version: 4.4.0
Operation System: Linux (same behaviour on windows)
uArm Controlling Method: uArm Studio
uArm User Facebook Group