uArm Swift Pro - Calibration

uArm Swift (Pro) Troubleshooting
1

Hi,

Can someone explain to me how the calibration of a uArm pro works?

I see there is the command M2401 to set the current position into the reference position. What what should this reference position be. What are the reference angles for each axis?

Regards,
Richard

1 Like
2

Hi @anykey

You can get the guide for manual calibration here:

3

When I send the M2401 B uarm returns E25 please can you tell me what this means?

4

Hi @Matthew_Burston

E25 means failed operation. It may be caused by two reasons:

  1. Power supply is not connected properly.
  2. The wires are not connected properly.
    image.png1036×216 95.4 KB

Please check the connections. Let me know of further problems. Thanks.

5

I was trying to calibrate the uArm since I have been seeing issues when trying to 3D print. It doesn’t stay on the same plane the entire time.

When I follow the pdf instructions at: https://drive.google.com/drive/folders/0B-L-tCvknXU9ZXBweVlYRXd5VHM

I was using Arduino and the COM and sending the M2019 command it does not disable the motors. Any help would be appreciated.

6

Hi @jrtaylor0319

Did you receive an “OK” after sending M2019?
If not, please choose “Newline”.

image.png1040×634 233 KB